HP NetServer AA 4000 Manual page 240

Chapter 13
IOPn.MtcMon status: An invalid packet has been received by the Monitor. Packet command = x.
Variables x – the transport command type of the received event
Severity Error
Description This message is generated if an IOP receives a message over the ESI or IL that has a legal
transport command type, but is not valid to be received by the IOP. The Fault Handler is
invoked, and an IOP or a CE may be removed as a result of this event.
Related Messages
IOPn.MtcMon status: IOPx has been removed from service.
IOPn.MtcMon status: CEx has been removed from service.
IOPn.MtcMon status: IOPx is faulted and requires repair.
IOPn.MtcMon status: CEx is faulted and requires repair.
Hardware/Software Usually, this message is a result of a software error. In rare cases, it can be due to a hardware
error that results in the corruption of data on an IOP or CE.
Action • When this message is generated, preserve the Fault Handler's event log information and
• If the IOP is removed as a result of the event, a crash dump may be generated.
• If this condition persists, contact your service provider for assistance.
IOPn.MtcMon status: An invalid request was made to remove IOPx.
Variables x – the ID of the IOP that was not removed
Severity Warning
Description A request internal to the Endurance software to remove an IOP from service was not valid.
Hardware/Software This message is generated as a result of a software operation.
Action • Report this Endurance software error to your service provider.
• You may have to power cycle the IOP to correct this condition.
230
examine it to gather additional information related to the message.
MtcMon Messages