HP NetServer AA 4000 Manual page 159

Chapter 9
IOPn.MtcFLOP status: The Floppy Provider attempted to respond to a request, but it was unable to send the reply back
to the Redirector.
Severity Error
Description An internal error has occurred in the HP NetServer AA software.
Action Contact your service provider for assistance.
IOPn.MtcFLOP status: The Floppy Provider could not register with the DSL.
Severity Error
Description The Floppy Provider was not able to register with the DSL.
Related Messages
IOPn.MtcMon status: A Monitor client failed to complete initialization
with the remote IOP during IOP joining. Client ID = x.
IOPn.MtcMon status: A Monitor client failed to initialize with the remote
IOP during IOP joining. Client ID = x.
Action • Check the Event Viewer for any related messages.
• Refer to those messages for more information.
IOPn.MtcFLOP status: The registration of logical devices failed. This indicates a setup problem with the FLOP subkey
under Marathon\Providers in the Registry.
Severity Error
Description The Windows NT Registry does not accurately define the floppy devices on this IOP. The
Registry information for floppy devices is automatically supplied, based on the parameters that
you supplied using the HP NetServer AA Configuration Utility.
Action • Using the HP NetServer AA Configuration Utility, check the configuration information
• Make any necessary corrections. Remember that when you make a change using the HP
• Because any changes will not take effect until the IOP reboots, schedule an appropriate
• Check the Event Viewer for a previously logged message that indicates the cause of this
that you supplied for each floppy device.
NetServer AA Configuration Utility, you must make the same change on both IOPs. (The
IOPs must contain identical configuration files.)
time to reboot the IOPs.
message; refer to the description of that message for more information.
MtcFLOP and MtcFLOR Messages
149