HP NetServer AA 4000 Manual page 24

Chapter 1
Table 1-5HP NetServer AA Message Summary – Prefixed Messages
Message
IOPn.MtcDgs status: Datagram Service protocol version mismatch.
IOPn.MtcDgs status: Error accessing data in the Registry.
IOPn.MtcDgs status: Error in NIC bindings.
IOPn.MtcDgs status: Error transferring incoming Ethernet packet to the receive buffer.
IOPn.MtcDgs status: Ethernet transmit error.
IOPn.MtcDgs status: Incomplete transfer of incoming Ethernet packet to the receive buffer.
IOPn.MtcDgs status: Initialization error
IOPn.MtcDgs status: Invalid Ethernet packet received.
IOPn.MtcDgs status: Invalid Registry parameter. Using default value.
IOPn.MtcDgs status: NIC receive data lookahead buffer is too small.
IOPn.MtcDgs status: Receive packet allocation failure.
IOPn.MtcDgs status: Send packet allocation failure.
IOPn.MtcDgs status: Unable to open NIC.
IOPn.MtcDgs status: Unable to query or set NIC.
IOPn.MtcDsl status: A packet with an invalid transport command was received
(offendingValue).
IOPn.MtcDsl status: A provider has an invalid Registry entry (provName).
IOPn.MtcDsl status: A provider has attempted to register more than once (provName).
IOPn.MtcDsl status: A request contained an invalid provider ID (offendingValue).
IOPn.MtcDsl status: A request for provider provName used an invalid logical device ID.
IOPn.MtcDsl status: A request for provider provName used an invalid physical device ID.
IOPn.MtcDsl status: A tack timeout condition was not cleared properly.
IOPn.MtcDsl status: A tacked flush packet has an unknown flush type (offendingValue).
IOPn.MtcDsl status: An invalid client callback ID was encountered (offendingValue).
IOPn.MtcDsl status: An invalid component state was encountered (offendingValue).
14
Introduction
Page
page 91
page 91
page 91
page 92
page 92
page 92
page 92
page 93
page 93
page 93
page 93
page 94
page 94
page 94
page 98
page 98
page 98
page 99
page 99
page 100
page 100
page 100
page 101
page 101