HP NetServer AA 4000 Manual page 277

Chapter 13
IOPn.MtcMon status: No ECC or parity memory detected on CEx.
Chipset: vendor chipset.
Memory mode: mode.
IPMI found: Y/N
Variables x – the ID of the CE that has no ECC or parity memory
Y – IPMI was found in CEx
N – IPMI was not found in CEx
Severity Warning
Description The CE software has determined that no ECC or parity memory exists on the CE. The lack of
this type of memory increases the risk of the CEs having data corruption or divergence.
This information is logged on the IOP that controls the booting and synchronizing of the CEs.
Hardware/Software This message occurs as a result of CE hardware configuration information.
Action • No action is required. However, Marathon recommends that you configure your
• If you need help in determining whether you are using a qualified CE in your Endurance
IOPn.MtcMon status: Removing CEx so crash dump can proceed with only one active CE.
Variables x – the ID of the CE being removed
Severity Warning
Description The Windows NT operating system running on the CE(s) has crashed and is attempting to
generate a crash dump. This occurs if Windows NT initiates a crash dump and you configured
Windows NT to generate a crash dump on system failures. All but one active CE is removed
from service while the crash dump is being performed.
Related Messages
IOPn.MtcMon status: A crash dump is being taken for the Windows NT
operating system running on the CEs.
IOPn.MtcMon status: CEx has been removed from service.
Hardware/Software This message is generated as a result of a hardware or software failure on the CE(s) that
resulted in a crash of Windows NT.
Action No action is required if the crash was intentional. The CE(s) automatically reboot and
resynchronize when the crash dump completes.
• Save the resulting memory.dmp file for offsite analysis.
• Repair the hardware or software failure at the next opportunity.
Endurance server so that it has ECC or parity memory.
server, contact your service provider.
MtcMon Messages
267