HP NetServer AA 4000 Manual page 314

Chapter 14
IOPn.MtcScsiP status: Attempt to restart mirror copy for DISKn has failed. Cannot access target disk for mirror copy.
Check prior events for details.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description HP NetServer AA SCSI software was unable to restart a mirror copy as requested by the
administrator.
Action Check the event log for previous messages that indicate why the mirror copy could not be
restarted. For example, if one of the mirrored disks had failed a read or a write request, then it
would not be eligible for a mirror copy until it had been successfully enabled.
IOPn.MtcScsiP status: Bad block remapping during mirror copy for DISKn is disabled.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Warning
Description The administrator has used the HP NetServer AA Manager to disallow the bad block
remapping for diskn. If and when it acts as the mirror copy source disk, any bad blocks that are
encountered cause the mirror copy to fail.
Action No action is required.
IOPn.MtcScsiP status: Bad block remapping during mirror copy for DISKn is enabled.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Warning
Description The administrator has used the HP NetServer AA Manager to give HP NetServer AA SCSI
software permission to remap any bad blocks encountered during a mirror copy. This option
will be turned off after a successful mirror copy.
Action No action is required.
304
MtcScsiP and MtcScsiR Messages