HP NetServer AA 4000 Manual page 280

Chapter 13
IOPn.MtcMon status: The boot process has completed for CEx.
Variables x – the ID of the booting CE
Severity Informational
Description The specified CE has successfully completed the boot process and is active in the Endurance
server.
Related Messages
IOPn.MtcMon status: The boot process has begun for CEx.
Hardware/Software A software process completed.
Action No action is required.
IOPn.MtcMon status: The boot process has failed for CEx.
Variables x – the ID of the booting CE
Severity Error
Description When a CE is powered up and an IOP is active, the boot process is started on the CE. If the
process does not succeed, this message is generated.
Related Messages
IOPn.MtcMon status: The boot process has started for CEx.
IOPn.MtcMon status: CEx has been removed from service.
IOPn.MtcMon status: CEx could not be booted because the boot device is
not available on IOPx.
IOPn.MtcMon status: A conflict was detected during CE boot with remote
IOPx.
IOPn.MtcMon status: A conflict was detected during CE boot with remote
IOPx.
IOPn.MtcMon status: Conflicting IOP IDs have been detected in the
Endurance System. Local IOP ID = x Remote = y
Hardware/Software This message is generated as a result of an Endurance hardware configuration error, hardware
failure, or software failure.
Action The action you take depends on the reason for the CE boot process failure. Examine the
associated messages for additional information about the failure.
270
MtcMon Messages