HP NetServer AA 4000 Manual page 208

Chapter 13
IOPn.MtcMon Fault Handler status: Removed CEx because of divergence induced by a path error.
Variables x – the ID of the CE that was removed
Severity Error
Description Occasionally, a condition that requires the removal of an IOP can also generate divergence
between the CEs.The Endurance software detects this condition and prevents divergence by
proactively removing a CE along with the IOP.
When a CE needs to be removed along with an IOP to prevent divergence, this message is
logged. This message is always logged with a message that results in the removal of an IOP.
Related Messages
IOPn.MtcMon FRU: IOPx <-> CEx INTERCONNECT fault.
IOPn.MtcMon Fault Handler status: Fault event processing complete.
Removed Units: CEx, IOPx
IOPn.MtcMon Fault Handler status: The Fault Handler received a packet from another IOP that is not a member of this
Endurance system. This may mean that you have multiple Endurance systems on your network with the same
Endurance Kit Number.
This problem should be corrected immediately; otherwise, you may lose network packets or encounter network
connectivity problems.
Severity Error
Description The local IOP is receiving packets from an IOP other than one that is the opposite member of
this Endurance system. Because the network address used to route these packets is based on
the Endurance kit number, this indicates that there is another system on the local area network
that has been installed with the same kit number.
This problem should be corrected immediately. Network traffic between the Endurance
systems in conflict and other systems on the network may become disrupted. You may lose
packets or otherwise encounter network connectivity problems.
Related Messages
IOPn.MtcEthP status: A duplicate address has been detected on device
x (y).
Action • Start the Endurance Manager on the local IOP.
• On the menu bar, select the View
• Use the Endurance Manager on the IOPs on other Endurance systems in the network to
• Shut down one of the systems in conflict and re-install the Endurance software on the
198
subsequently displayed contains the Endurance kit number.
find the system with the duplicate Endurance kit number.
IOPs and the CEs, using the unique Endurance kit number that was shipped with the
Endurance software for that system.
Revision Levels... function. The first line
MtcMon Messages