HP NetServer AA 4000 Manual page 229

Chapter 13
IOPn.MtcMon status: A protocol error was detected on IOPx during IOP joining.
Variables x – the ID of the IOP on which the protocol error was detected
Severity Error
Description After an IOP completes initialization with a remote IOP, it attempts to join the Endurance
server configuration. A series of control messages are exchanged between IOPs as part of this
process. An illegal message was detected by an IOP during this sequence, or a missing message
was detected.
Related Messages
IOPn.MtcMon status: The join process has failed for IOPx.
IOPn.MtcMon status: IOPx is faulted and requires repair.
Hardware/Software An error was detected by Endurance server software. It is either:
• The result of a software error
• An unexpected transition, that can be caused by either hardware or software
Action This message can occur if the system experiences an unexpected transition, such as loss of an
IOP or CE, during IOP initialization. This message is thresholded. If the threshold is not
exceeded, the IOP joining process is retried. If the retry is not successful, an IOP is faulted
when the threshold is exceeded.
• If this condition occurs in the absence of any related messages, make sure that the
• If the condition persists, contact your service provider for assistance.
IOPn.MtcMon status: An Endurance Manager command has been issued to disable CEx.
Variables x – the ID of the CE to be disabled
Severity Warning
Description This message is generated as a result of issuing a CE Disable command.
Related Messages
IOPn.MtcMon status: CEx has been disabled by operator request.
IOPn.MtcMon status: The CE remove or disable operation failed.
Hardware/Software This message is generated as a result of a software operation.
Action No action is required unless this message is followed by IOPn.MtcMon status: The
CE remove or disable operation failed. In this case, refer to the message
IOPn.MtcMon status: The CE remove or disable operation failed
for a corrective action.
Endurance server IOPs are using compatible software. If the revisions are not compatible,
reinstall them if necessary.
MtcMon Messages
219