HP NetServer AA 4000 Manual page 281

Chapter 13
IOPn.MtcMon status: The boot process has failed for CEx because the 16-bit platform initialization did not complete
successfully.
Variables x – the ID of the booting CE
Severity Error
Description The specified CE could not be booted because the 16-bit platform initialization process failed.
This process is performed via a module uploaded from the IOP and is based on the CE
hardware platform specified during IOP installation of the Endurance software.
Related Messages
IOPn.MtcMon status: CEx has been removed from service.
Hardware/Software This message is generated as a result of a software configuration error.
Action • Reinstall the Endurance software on the IOP that generated this event log entry.
• When prompted, be sure to specify the hardware platform that matches the CE hardware
• If the problem persists, record the error information displayed on the CE during boot, and
IOPn.MtcMon status: The boot process has started for CEx.
Variables x – the ID of the booting CE
Severity Informational
Description The specified CE began the boot process. The boot process occurs immediately after the CE is
powered on.
Related Messages
IOPn.MtcMon status: The boot process has completed for CEx.
IOPn.MtcMon status: The boot process has failed for CEx.
Hardware/Software A software process started.
Action No action is required.
type.
contact your service provider for assistance.
MtcMon Messages
271