HP NetServer AA 4000 Manual page 118

Chapter 6
IOPn.MtcDsl status: Unable to initialize the DSL.
Severity Error
Description The Device Synchronization Layer was unable to initialize due to lack of main memory. This
message indicates an operating system resource condition usually related to insufficient
memory in the reporting IOP.
Related Messages
IOPn.MtcDsl status: Unable to allocate callback worker thread.
IOPn.MtcDsl status: Provider provName experienced an internal failure.
Hardware/Software This message indicates an operating system resource condition caused by insufficient IOP
memory.
Action • Add more memory to the reporting IOP.
• If there is sufficient memory in the IOP, contact your service provider for assistance.
IOPn.MtcDsl status: Unable to run provider's callback routine provName.
Severity Error
Description This message indicates an operating system resource condition usually related to insufficient
memory in the reporting IOP.
Related Messages
IOPn.MtcDsl status: Unable to allocate callback worker thread.
Hardware/Software This message usually indicates an operating system resource condition caused by insufficient
memory in the reporting IOP.
Action • Add more memory to the reporting IOP.
• If there is sufficient memory in the IOP, contact your service provider for assistance.
IOPn.MtcDsl status: Unable to start a full flush due to an internal software error.
Severity Error
Description This message occurs only when HP NetServer AA server software has failed a consistency
check.
Hardware/Software This message indicates an internal HP NetServer AA server software error.
Action Report this message to your service provider. If this message occurs, it does not affect
an HP NetServer AA server. Any elements (IOPs or CEs) removed as the result of the error
can be rebooted safely. Refer to
or information on how to reboot an IOP.
108
Chapter 9 in HP NetServer AA Solution Administrator's Guide
MtcDsl Messages