HP NetServer AA 4000 Manual page 305

Hp netserver aa 6200 solution release 3.0 messages
Hide thumbs Also See for NetServer AA 4000:
Table of Contents

Advertisement

Chapter 14
Table 14-1 MtcScsiP and MtcScsiR Status Message Summary (Continued)
Message
IOPn.MtcScsiP status: Cannot obtain SCSI mode page data for DISKn. This is typical for RAID
controllers.
IOPn.MtcScsiP status: Cannot obtain SCSI read-write recovery mode page data for DISKn. This is
typical for RAID controllers.
IOPn.MtcScsiP status: CDROMn may not be SCSI-2 (or newer SCSI standard) compliant.
IOPn.MtcScsiP status: Command not valid for non-mirrored disks.
IOPn.MtcScsiP status: Command to DISKn not valid because it is a non-mirrored disk. HP NetServer
AA Manager request to non-mirrored disk was ignored.
IOPn.MtcScsiP status: Configured ADAPTERn failed to reset bus BUSx. Disks connected to this
adapter may be marked faulted.
IOPn.MtcScsiP status: Configured ADAPTERx has a misconfigured bus ID BUSn. Use the HP
NetServer AA Configuration Utility to change the bus ID.
IOPn.MtcScsiP status: Configured ADAPTERx has different initiator IDs for bus BUSn. Use the
BIOS setup program available via your SCSI adapter to reconfigure the initiator ID. The IOPs will not
be allowed to join until this problem is resolved.
IOPn.MtcScsiP status: Copy for selected disk has not failed.
IOPn.MtcScsiP status: Device DISKn has failed. See prior events for reason.
IOPn.MtcScsiP status: Device DISKn will be faulted because it is taking too long to complete SCSI
requests. The IOP must be rebooted before the disk can be enabled.
IOPn.MtcScsiP status: DEVICEn has a SCSI adapter number different than configured on the other
IOP, and it will be marked offline.
IOPn.MtcScsiP status: DEVICEn has a SCSI bus number different than configured on the other IOP,
and it will be marked offline.
IOPn.MtcScsiP status: DEVICEn has a SCSI logical unit number (LUN) different than configured on
the other IOP, and it will be marked offline.
IOPn.MtcScsiP status: DEVICEn has a target ID different than configured on the other IOP, and it
will be marked offline.
IOPn.MtcScsiP status: DEVICEn location contains an unsupported device.
IOPn.MtcScsiP status: DEVICEn location does not contain the expected device type.
IOPn.MtcScsiP status: DEVICEn powered up successfully.
IOPn.MtcScsiP status: DEVICEn was not found, and it will be marked offline.
MtcScsiP and MtcScsiR Messages
Page
page 307
page 307
page 308
page 308
page 309
page 309
page 309
page 310
page 310
page 310
page 311
page 311
page 311
page 312
page 312
page 312
page 313
page 313
page 313
295

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netserver aa 6200

Table of Contents