HP NetServer AA 4000 Manual page 355

Chapter 14
IOPn.MtcScsiP status: Unable to read and process the HP NetServer AA partition of DISKn, and it will be marked
offline.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description A fatal disk error occurred which prevents HP NetServer AA disk subsystem software from
reading and processing the MTC sector of a disk.
Action • Review the event log, looking for any previous message that may explain why this
• If you find none, use the HP NetServer AA Manager to reset the HP NetServer AA sector.
•
IOPn.MtcScsiP status: Unable to read one or more CE requested sectors SECTORn - SECTORm for DISKx. If DISKx
stays online, this error may be considered transient. Many transient errors may indicate the need for disk
replacement.
Variables x – the disk number; for example, DISK0, DISK1, DISK2
SECTORn – the starting sector in the range of sectors
SECTORm – the ending sector in the range of sectors
Severity Error
Description A CE read request did not complete despite repeated retries. The disk's state will be set to
faulted. The sector addresses listed in the message indicate sectors that may contain bad spots.
Action If the disk is the source disk for a mirror copy or if the disk was the only online member of the
mirror set, then the mirror set will become unavailable to the CEs. You may be able to reenable
the disk, but if it continues to fail, you may need to replace the disk. It is also a good idea to
verify the SCSI termination and SCSI device connections.
If both members of the mirror set were online prior to the read error, then no interruption of
service for this mirror set will occur. You can reenable the disk that experienced the read error,
and a copy to that disk will begin. In most cases, the disk will be perfectly usable after the
mirror copy. However, if the disk continues to fail, you may need to replace it.
message occurred.
If the condition persists, contact your service provider for assistance.
MtcScsiP and MtcScsiR Messages
345