HP NetServer AA 4000 Manual page 358

Chapter 14
IOPn.MtcScsiP status: Unable to remap bad block at SECTOR for DISKn during a mirror copy.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
SECTOR – the sector number of the sector unable to be remapped
Severity Error
Description During a mirror set copy, the source disk encountered a bad block. The software attempted to
remap the bad block, but the attempt failed. There may be no more spare blocks to permit a
remap, and the disk may need replacement.
Action • Use the HP NetServer AA Manager to reset the mirror copy. A new mirror copy will be
•
• If you find no problems, back up all data from the source disk, and replace the source disk.
IOPn.MtcScsiP status: Unable to reset HP NetServer AA partition for DISKn.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description An attempt was made to reset the HP NetServer AA partition for the specified disk. However,
the attempt failed. Check the event log for previous entries to determine the reason for the
failure. Most likely, reasons include the disk was not found; the disk has failed; or the disk is
not accessible.
Action • Reboot the IOP and determine why the disk was not found.
• Check for a powered-off state, the disk not being connected to SCSI bus, or a faulted disk.
•
348
started.
If the new mirror copy also fails, then check the SCSI termination and cabling for
problems.
See Chapter 9 in HP NetServer AA Solution Administrator's
a mirrored disk.
Note: The bad spot on the disk may or may not affect the integrity of the file system.
Whether it has an effect will become apparent as you attempt to back up your data.
If the condition persists, contact your service provider for assistance.
MtcScsiP and MtcScsiR Messages
Guidefor details on replacing