HP NetServer AA 4000 Manual page 25

Hp netserver aa 6200 solution release 3.0 messages
Hide thumbs Also See for NetServer AA 4000:
Table of Contents

Advertisement

Chapter 1
Table 1-5HP NetServer AA Message Summary – Prefixed Messages (Continued)
Message
IOPn.MtcDsl status: An invalid component type was encountered (offendingValue).
IOPn.MtcDsl status: An invalid DSL packet ID was encountered (offendingValue).
IOPn.MtcDsl status: An invalid IOP state was encountered (offendingValue).
IOPn.MtcDsl status: An invalid logical device operation type was encountered
(offendingValue).
IOPn.MtcDsl status: An invalid packet descriptor was encountered.
IOPn.MtcDsl status: An invalid reset reason code was encountered (offendingValue).
IOPn.MtcDsl status: An invalid resync flush state was encountered (offendingValue).
IOPn.MtcDsl status: An invalid subprovider ID was encountered (offendingValue).
IOPn.MtcDsl status: An invalid transaction ID was encountered (offendingValue).
IOPn.MtcDsl status: Invalid device entries in the IOP's configuration were pruned. This
indicates an improperly set up device configuration. This problem may have occurred due to
hand modifications of the Windows NT Registry. The problem may be fixed by re-running
the HP NetServer AA Configuration Utility.
IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx
is offline.
IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx
is online.
IOPn.MtcDsl status: Provider provName experienced an internal failure.
IOPn.MtcDsl status: The IOPs could not be joined because IOP 1 has a different device
configuration than IOP 2. This problem may be fixed by comparing the configurations and
making them consistent.
IOPn.MtcDsl status: Unable to allocate a callback descriptor.
IOPn.MtcDsl status: Unable to allocate a callback worker thread.
IOPn.MtcDsl status: Unable to find a flush descriptor on the global flush list.
IOPn.MtcDsl status: Unable to initialize the DSL.
IOPn.MtcDsl status: Unable to run provider's callback routine provName.
IOPn.MtcDsl status: Unable to start a full flush due to an internal software error.
IOPn.MtcEthP status: A call to NdisRequest timed out.
Introduction
Page
page 101
page 102
page 102
page 103
page 103
page 103
page 104
page 104
page 104
page 105
page 105
page 106
page 106
page 106
page 107
page 107
page 107
page 108
page 108
page 108
page 115
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netserver aa 6200

Table of Contents