HP NetServer AA 4000 Manual page 145

Chapter 7
IOPn.MtcEtx status: Registry parameter mismatch between IOPs. Using default value.
Severity Warning
Description MtcEtx includes the current parameter values in the Control PDUs used to establish a virtual
circuit. This message is logged if the parameters on the IOPs do not agree. The Event Log Data
section contains the invalid parameter value. MtcEtx will use the default value for the
parameter.
Another possible cause for this error is a change in the default parameter values between
MtcEtx versions. This message is also logged if one IOP is upgraded to a new version of the
HP NetServer AA software and rebooted without simultaneously upgrading and rebooting the
other IOP.
Action • Run a Registry editor and note the values under
• Contact your service provider for further assistance.
See Also The HP NetServer AA Manager command IOPn.IopLinkDriver Show Parameter Values.
IOPn.MtcEtx status: Send buffer descriptor allocation failure.
Severity Error
Description MtcEtx was unable to allocate an NDIS_BUFFER resource needed to transmit an Ethernet
packet. This can be a fatal error, and results in the IOP being shut down.
Action Contact your service provider for assistance.
IOPn.MtcEtx status: Send packet allocation failure.
Severity Error
Description MtcEtx was unable to allocate an NDIS_PACKET resource needed to transmit an Ethernet
packet. This can be a fatal error, and results in the IOP being shut down.
Action Contact your service provider for assistance.
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\MtcEtx
.
\Parameters
MtcEthP and MtcEtx Messages
135