HP NetServer AA 4000 Manual page 266

Chapter 13
IOPn.MtcMon status: IOPx has been enabled by operator request.
Variables x – the ID of the IOP that has been enabled
Severity Informational
Description The specified IOP was enabled using an IOP Enable Operation or Tuple Enable Operation
command. The IOP had previously been in a faulted or disabled state and is now available for
configuration into the Endurance server.
Related Messages
IOPn.MtcMon status: IOPx is faulted and requires repair.
IOPn.MtcMon status: IOPx has been disabled by operator request.
IOPn.MtcMon status: The Tuplex shutdown or disable completed
successfully.
Hardware/Software This message is generated as a result of issuing a software command.
Action No action is required.
IOPn.MtcMon status: IOPx has been removed from service.
Variables x – the ID of the IOP that has been removed from service
Severity Informational
Description The specified IOP was removed from the Endurance server. The removal may occur as a result
of either:
• A failure that requires the removal of the IOP
• An Endurance Manager or MTCCONS command
• A normal shutdown of the Windows NT operating system on the IOP
Related Messages
IOPn.MtcMon status: IOPx has been disabled by operator request.
IOPn.MtcMon status: IOPx is faulted and requires repair.
IOPn.MtcMon status: The Windows NT operating system on the local IOP is
being shut down.
IOPn.MtcMon status: IOPx is being shut down by operator request.
Hardware/Software This message can be generated as a result of a hardware or software failure or issuing a
command to shut down the IOP's operating system.
Action • If the IOP was removed as a result of a command, no action is necessary.
• If the IOP was removed as a result of a fault, examine the event logs to determine the
• Repair the failure and reboot the IOP. Refer to
256
source of the failure.
Administrator's Guide for information about how to reboot an IOP.
MtcMon Messages
Chapter 9 in HP NetServer AA Solution