HP NetServer AA 4000 Manual page 306

Hp netserver aa 6200 solution release 3.0 messages
Hide thumbs Also See for NetServer AA 4000:
Table of Contents

Advertisement

Chapter 14
Table 14-1 MtcScsiP and MtcScsiR Status Message Summary (Continued)
Message
IOPn.MtcScsiP status: Disk could not be enabled.
IOPn.MtcScsiP status: Disk is a mirror copy target. Status is offline pending copy start.
IOPn.MtcScsiP status: Disk is already disabled.
IOPn.MtcScsiP status: Disk is already online.
IOPn.MtcScsiP status: Disk must be offline.
IOPn.MtcScsiP status: DISKn cannot be accessed for initialization, and it will be marked offline.
IOPn.MtcScsiP status: DISKn cannot be physically accessed. See prior events for reason.
IOPn.MtcScsiP status: DISKn contains an invalid partition table. The disk must be repartitioned.
IOPn.MtcScsiP status: DISKn contains too few partitions. Use Disk Administrator in Offline HP
NetServer AA I/O Processor Mode to partition the disk, making sure to add an HP NetServer AA
partition.
IOPn.MtcScsiP status: DISKn copy target on IOPx has been newly installed, but copy source on IOPy
has not. Install CE and IOP software on copy source (IOPy).
IOPn.MtcScsiP status: DISKn could not be enabled. Check prior events for reason.
IOPn.MtcScsiP status: DISKn did not come ready, and it will be marked offline.
IOPn.MtcScsiP status: DISKn did not power up properly, and it will be marked offline.
IOPn.MtcScsiP status: DISKn does not have a bootable partition. Use Disk Administrator in Offline
HP NetServer AA I/O Processor Mode to mark the desired boot partition as active. The disk will be
kept offline until it contains a partition marked as bootable.
IOPn.MtcScsiP status: DISKn does not support automatic bad block remapping for recoverable read
requests.
IOPn.MtcScsiP status: DISKn does not support automatic bad block remapping for write requests.
IOPn.MtcScsiP status: DISKn encountered a bad block at SECTOR during a mirror copy.
IOPn.MtcScsiP status: DISKn encountered a write error during a mirror copy.
IOPn.MtcScsiP status: DISKn failed a SCSI request, and repeated retries did not succeed. The disk
will be marked faulted.
IOPn.MtcScsiP status: DISKn had a previous failure. The device must be manually enabled, using the
HP NetServer AA Manager, before it can be used.
296
MtcScsiP and MtcScsiR Messages
Page
page 313
page 314
page 314
page 314
page 314
page 315
page 315
page 315
page 316
page 316
page 316
page 317
page 317
page 318
page 318
page 318
page 319
page 319
page 320
page 320

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netserver aa 6200

Table of Contents