HP NetServer AA 4000 Manual page 219

Chapter 13
IOPn.MtcMon FRU: Processing capability failure on unspecified IOP.
Severity Error
Description An error occurred that originated from an IOP, but the details were not sufficient to determine
which IOP caused the condition.
Action • Run diagnostics on each IOP to determine if one of them is faulty.
• If this condition persists without other errors, contact your service provider for assistance.
IOPn.MtcMon FRU: Target operating system or subcomponent failure.
Severity Error
Description This message indicates a failure of:
• The Windows NT operating system
• A device driver
• Other kernel-level software
Usually, this means that both CEs crashed, or a stop error with screen dump was encountered.
However, it can also indicate a problem in which erroneous responses or requests are being
generated by CE software that interferes with the system's ability to continue processing. It
may also be due to excessive CPU load or memory requirements.
Action • If the system experienced a stop error with screen dump, follow the instructions for
• Monitor CE resource usage to ensure that the CPU and memory load are reasonable for
• If this condition persists, contact your service provider for assistance.
Note: The IOP removed as a result of this error may not be the source of the fault.
dealing with the stop error as described in any software package you have installed on the
CE.
your system.
MtcMon Messages
209