Page of 1

HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual

Basic cable connections: document change list - hp rp2400 series of servers.
Hide thumbs
   
Basic Cable Connections - HP rp2400 Series of Servers - Document Changes
The document Basic Cable Connections - HP rp2400 Series of Servers has been revised. See the table below.
IMPORTANT The latest versions of these documents, and any updates to these documents, are posted under
the appropriate server at http://docs.hp.com.
Ver. 1.0
Ver. 2.0
Page #
Page #
2
2
3
7
4
8
5
9
6
10
6
10
v1
Printed in the U.S.A.
Send documentation comments to http://docs.hp.com/assistance/index.html.
For detailed installation, maintenance, and technical information, refer to the
rp24xx Hardware Manual and other documentation (search on rp2400) at
http://docs.hp.com.
2. (Amber) Attention (ATTN) LED - When lit, indicates that a condition exists that
requires operator attention and assistance from HP Support.
NOTE: For technical support please call your local support hotline or contact HP
at http://www.hp.com/support.
NOTE: For more information on console configuration, refer to the rp24xx
Hardware Manual (search on rp2400) at http://docs.hp.com.
Using a Secure Web Console PCI card as a System Console. If the Secure
Web Console PCI card is to be used as a system console, first configure the
Guardian Service Processor (GSP). For more information on GSP configuration,
refer to the rp24xx Hardware Manual (search on rp2400) at http://docs.hp.com.
Then, connect an RJ45 LAN cable to the Secure Web Console PCI card installed
in an I/O card slot on the back of the server.
Using the LAN Console as a System Console. If a LAN Console is to be used
as a system console, first configure the Guardian Service Processor (GSP). For
more information on GSP configuration, refer to the rp24xx Hardware Manual
(search on rp2400) at http://docs.hp.com.
Then, connect it to the system with an RJ45 LAN cable to the RJ45 connector
labeled 10BASE-T LAN Console connection on the back of the server.
NOTE: [regarding connecting Power Distribution Units (PDUs) to Dedicated AC
Input Receptacles] Current requirements vary with input voltage, server
configuration, and number of power supplies installed. Refer to "System Site
Preparation" in the rp24xx Hardware Manual at http://docs.hp.com.
Description of Change
rp24xx_cable_change_list

Advertising

   Related Manuals for HP A4500A - VMEbus Single Board Computer 744 Motherboard

This manual also for:

Rp2400

Comments to this Manuals

Symbols: 0
Latest comments: