Dell Force10 C150 Configuration Manual page 716

Use any or all of the following commands in CONFIGURATION INTERFACE mode to change OSPFv2
parameters on the interfaces:
Command Syntax
ip ospf
cost
ip ospf dead-interval
ip ospf hello-interval
ip ospf message-digest-key
md5
key
ip ospf priority
ip ospf retransmit-interval
ip ospf transmit-delay
show config
Use the
configurations. Use the
OSPF process.
716 | Open Shortest Path First (OSPFv2 and OSPFv3)
Command Mode
CONFIG-INTERFACE
CONFIG-INTERFACE
seconds
The dead interval must be four times the hello interval.
The dead interval must be the same on all routers in the OSPF network.
seconds CONFIG-INTERFACE
The hello interval must be the same on all routers in the OSPF network.
CONFIG-INTERFACE
keyid
Be sure to write down or otherwise record the Key. You cannot learn the key
once it is configured.
You must be careful when changing this key.
CONFIG-INTERFACE
number
seconds CONFIG-INTERFACE
The retransmit interval must be the same on all routers in the OSPF network.
CONFIG-INTERFACE
seconds
The transmit delay must be the same on all routers in the OSPF network.
command in CONFIGURATION INTERFACE mode
show ip ospf interface
Usage
Change the cost associated with OSPF traffic on
the interface.
Cost: 1 to 65535 (default depends on the
interface speed).
Change the time interval the router waits before
declaring a neighbor dead. Configure Seconds
range: 1 to 65535 (default is 40 seconds).
Change the time interval between hello-packet
transmission.
Seconds range: from 1 to 65535 (default is 10
seconds).
Use the MD5 algorithm to produce a message
digest or key, which is sent instead of the key.
Keyid range: 1 to 255
Key: a character string
Change the priority of the interface, which is
used to determine the Designated Router for the
OSPF broadcast network.
Number range: 0 to 255 (the default is 1).
Change the retransmission interval between
LSAs.
Seconds range: from 1 to 65535 (default is 5
seconds).
Change the wait period between link state
update packets sent out the interface. Seconds
range: from 1 to 65535 (default is 1 second).
command in EXEC mode to view interface status in the
(Figure 32-16) to view interface