Dynamic Counters - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)

Hide thumbs Also See for Force10 C150:

Table of Contents

Dynamic Counters

By default, counting for the following four applications is enabled:

For remaining applications, FTOS automatically turns on counting when the application is enabled, and is

turned off when the application is disabled. Please note that if more than four counter-dependent

applications are enabled on a port pipe, there is an impact on line rate performance.

The following counter-dependent applications are supported by FTOS:

Ingress VLAN

Show Quick Links

Table of Contents