Dell Force10 C150 Configuration Manual page 253

Step Command Syntax
router bgp
4
as-number
neighbor {
5
ip-address
} route-map
peer-group-name
{ in | out }
map-name
To view the BGP configuration, use the
mode. To view a route map configuration, use the
Change NEXT_HOP attribute
You can change how the NEXT_HOP attribute is used.
Use the following command in the CONFIGURATION ROUTER BGP mode to change the how the
NEXT_HOP attribute is used.
Command Syntax
neighbor {
ip-address |
} next-hop-self
peer-group-name
show config
Use the
bgp
command in EXEC Privilege mode to view BGP configuration.
You can also use route maps to change this and other BGP attributes. For example, you can include the
following command in a route map to specify the next hop address:
Command Syntax
set next-hop
ip-address
Change WEIGHT attribute
Use the following command in CONFIGURATION ROUTER BGP mode to change the how the WEIGHT
attribute is used.
Command Syntax
neighbor {
|
ip-address
} weight
peer-group-name
show config
Use the
bgp
command in EXEC Privilege mode to view BGP configuration.
Command Mode
CONFIGURATION
| CONFIG-ROUTER-BGP
show config
Command Mode
CONFIG-ROUTER-B
GP
command in CONFIGURATION ROUTER BGP mode or the
Command Mode
CONFIG-ROUTE-M
AP
Command Mode
CONFIG-ROUTER-
weight BGP
command in CONFIGURATION ROUTER BGP mode or the
Purpose
Enter the ROUTER BGP mode.
Apply the route map to the neighbor or peer
group's incoming or outgoing routes.
command in the CONFIGURATION ROUTER BGP
show route-map
command in EXEC Privilege mode.
Purpose
Disable next hop processing and configure the
router as the next hop for a BGP neighbor.
Purpose
Sets the next hop address.
Purpose
Assign a weight to the neighbor connection.
• range: 0 to 65535
weight
• Default is 0
Border Gateway Protocol IPv4 (BGPv4) | 253
show running-config
show running-config