Dell Force10 C150 Configuration Manual page 945

Figure 45-13. Trace list Using seq Command Example
FTOS(config-trace-acl)#seq 15 deny ip host 12.45.0.0 any log
FTOS(config-trace-acl)#seq 5 permit tcp 121.1.3.45 0.0.255.255 any
FTOS(config-trace-acl)#show conf
!
ip trace-list dilling
seq 5 permit tcp 121.1.0.0 0.0.255.255 any
seq 15 deny ip host 12.45.0.0 any log
If you are creating a Trace list with only one or two filters, you can let FTOS assign a sequence number
based on the order in which the filters are configured. FTOS assigns filters in multiples of 5.
To configure a filter for a Trace list without a specified sequence number, use any or all of the following
commands in the TRACE LIST mode:
Command Syntax
deny permit ip | ip-protocol-number
{
{ | }
any host ip-address
| |
mask
host ip-address count
| } [
} {
source
any
} { |
destination mask
byte log
[ ] | ]
Command Mode Purpose
TRACE LIST Configure a deny or permit filter to
examine IP packets. Configure the
following required and optional
parameters:
•
•
•
•
•
•
•
•
•
•
ip
: to specify IP as the protocol to
filter for.
ip-protocol-number range: 0 to 255.
: An IP address as the source IP
source
address for the filter to match.
a network mask
mask:
any
: to match any IP source address
host ip-address:
to match IP addresses
in a host.
destination : An IP address as the
source IP address for the filter to
match.
count:
count packets processed by the
filter.
byte:
count bytes processed by the
filter.
log:
is supported.
Security | 945