View Advanced Interface Information; Display Only Configured Interfaces - Dell Force10 C150 Configuration Manual

Figure 20-36. Setting Auto-Negotiation Options
FTOS(conf)# int gi 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end
exit
mode
no
For details on the
Command Reference
Adjust the keepalive timer
keepalive
Use the
interface sends keepalive messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command:
Command Syntax
keepalive [
seconds ]
To view the new setting, use the

View Advanced Interface Information

Display Only Configured Interfaces

The following options have been implemented for
(only) linecard interfaces. When the
configurations are displayed. Dummy linecard interfaces (created with the
like any other physical interface.
Figure 20-37 lists the possible show commands that have the configured keyword available:
Exit from configuration mode
Exit from autoneg configuration mode
Specify autoneg mode
Negate a command or set its defaults
speed duplex negotiation auto
, , and
.
command to change the time interval between keepalive messages on the interfaces. The
Command Mode
INTERFACE
show config
configured
commands, see the Interfaces chapter of the
Purpose
Change the default interval between keepalive
messages.
command in the INTERFACE mode.
show [ip | running-config] interfaces
keyword is used, only interfaces that have non-default
commands for
linecard
command) are treated
Interfaces | 457
FTOS