Dell Force10 C150 Configuration Manual page 522

Figure 23-7. Command Example:
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: EEEE.EEEE.EEEE
Manual area address(es):
47.0004.004d.0001
Routing for area address(es):
21.2223.2425.2627.2829.3031.3233
47.0004.004d.0001
Interfaces supported by IS-IS:
Vlan 2
GigabitEthernet 4/22
Loopback 0
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics:
Generate wide metrics:
Accept wide metrics:
FTOS#
When you change from one IS-IS metric style to another, the IS-IS metric value could be affected. For each
interface with IS-IS enabled, you can assign a cost or metric that is used in the link state calculation.
Use the following command in INTERFACE mode to change the metric or cost of the interface.
Command Syntax
isis metric
default-metric
level-2 ]
isis ipv6 metric
level-2 ]
show config
Use the
Privilege mode to view the interface's current metric.
Table 23-3. Correct Value Range for the isis metric command
Metric Style
wide
narrow
wide transition
522 | Intermediate System to Intermediate System
IS-Type: level-1-2
level-1-2
none
none
Command Mode
[ level-1 |
INTERFACE
[ level-1 |
INTERFACE
default-metric
command in INTERFACE mode or the
Correct Value Range
0 to 16777215
0 to 63
0 to 16777215
show isis protocol
Purpose
default-value
narrow, narrow-transition or transition. 0 to 16777215
if the metric style is wide or wide transition.
Default: 10.
Assign a metric for an IPv6 link or interface.
•
default-metric
transition metric styles; 0 to 16777215 for wide
metric styles.
Default is 10.
Default level is level-1.
Refer to
information on this command.
show isis interface
IS-IS metrics settings.
range: 0 to 63 if the metric-style is
range: 0 to 63 for narrow and
Configure IS-IS metric style and cost
command in EXEC
for more