Configure Interface Sampling Size - Dell Force10 C150 Configuration Manual

Figure 20-37. show Commands with configured Keyword Examples
FTOS#show interfaces configured
FTOS#show interfaces linecard 0 configured
FTOS#show interfaces gigabitEthernet 0 configured
FTOS#show ip interface configured
FTOS#show ip interface linecard 1 configured
FTOS#show ip interface gigabitEthernet 1 configured
FTOS#show ip interface br configured
FTOS#show ip interface br linecard 1 configured
FTOS#show ip interface br gigabitEthernet 1 configured
FTOS#show running-config interfaces configured
FTOS#show running-config interface gigabitEthernet 1 configured
In EXEC mode, the
their relevant configuration information. The
displays the interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs to
which the interface belongs.
Figure 20-38. show interfaces switchport Command Example
FTOS#show interfaces switchport
Name: GigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan
Name: GigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan
Name: GigabitEthernet 13/2
802.1QTagged: True
Vlan membership:

Configure Interface Sampling Size

rate-interval
Use the
statistics to display in the
Although any value between 30 and 299 seconds (the default) can be entered, software polling is done
once every 15 seconds. So, for example, if you enter "19", you will actually get a sample of the past 15
seconds.
All LAG members inherit the rate interval configuration from the LAG.
Figure 20-39
458 | Interfaces
show interfaces switchport
2
2
command, in INTERFACE mode, to configure the number of seconds of traffic
show interfaces
shows how to configure rate interval when changing the default value:
command displays only interfaces in Layer 2 mode and
show interfaces switchport
output.
command (Figure 20-38)