Implementing Ipv6 With Ftos - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Implementing IPv6 with FTOS

FTOS supports both IPv4 and IPv6, and both may be used simultaneously in your system.
Note: Dell Force10 recommends that you use FTOS version 7.6.1.0 or later when implementing
IPv6 functionality on an E-Series system.
Table 22-2
sections following the table give some greater detail about the feature. Specific platform support for each
feature or functionality is designated by the
Note: When both E-Series TeraScale and ExaScale are supported, only the
feature is supported by one or the other chassis, the specific symbols are shown: e
TeraScale or
Table 22-2. FTOS and IPv6 Feature Support
Feature and/or
Functionality
Basic IPv6 Commands
IPv6 Basic Addressing
IPv6 address types:
Unicast
IPv6 neighbor discovery 7.4.1
IPv6 stateless
autoconfiguration
IPv6 MTU path
discovery
IPv6 ICMPv6
IPv6 ping
IPv6 traceroute
IPv6 Routing
Static routing
Route redistribution
Multiprotocol BGP
extensions for IPv6
IPv6 BGP MD5
Authentication
490
|
IPv6 Addressing
lists the FTOS Version in which an IPv6 feature became available for each platform. The
e
for E-Series ExaScale.
x
FTOS Release Introduction
E-Series
E-Series
TeraScale
ExaScale C-Series S-Series
7.4.1
8.2.1
7.4.1
8.2.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
7.4.1
8.2.1
8.2.1.0
8.2.1.0
c e s
symbols.
Documentation and Chapter Location
7.8.1
7.8.1
IPv6 Basic Commands in the FTOS Command
Line Interface Reference Guide
7.8.1
7.8.1
Extended Address Space
7.8.1
7.8.1
IPv6 Neighbor Discovery
7.8.1
7.8.1
Stateless Autoconfiguration
7.8.1
7.8.1
Path MTU Discovery
7.8.1
7.8.1
ICMPv6
7.8.1
7.8.1
ICMPv6
7.8.1
7.8.1
ICMPv6
7.8.1
7.8.1
Assign a Static IPv6 Route
7.8.1
8.4.2
OSPF, IS-IS, and IPv6 BGP chapters in the
FTOS Command Line Reference Guide
7.8.1
8.4.2
IPv6 BGP in the FTOS Command Line
Reference Guide
8.2.1.0
8.4.2
IPv6 BGP in the FTOS Command Line
Reference Guide
e
symbol is shown. If a
for E-Series
t
in this chapter
in this chapter
in this chapter
in this chapter
in this chapter
in this chapter
in this chapter
in this chapter

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents