Monitoring Hardware Components With Snmp - Dell Force10 C150 Configuration Manual

Monitoring hardware components with SNMP

The SNMP traps and OIDs in
Table 60-4. SNMP Traps and OIDs
OID String
RPM
.1.3.6.1.4.1.6027.3.1.1.3.8
.1.3.6.1.4.1.6027.3.1.1.3.9
.1.3.6.1.4.1.6027.3.1.1.4.0.11
.1.3.6.1.4.1.6027.3.1.1.4.0.12
Line Card
.1.3.6.1.4.1.6027.3.1.1.2.3.1.15
.1.3.6.1.4.1.6027.3.1.1.4.0.1
.1.3.6.1.4.1.6027.3.1.1.4.0.2
.1.3.6.1.4.1.6027.3.1.1.4.0.3
.1.3.6.1.4.1.6027.3.1.1.4.0.7
.1.3.6.1.4.1.6027.3.1.1.1.4.0.5
.1.3.6.1.4.1.6027.3.1.1.1.4.0.6
Power Supply Unit
1182 | C-Series Debugging and Diagnostics
Table 60-4 provide information on C-Series hardware components.
OID Name
chRPMMajorAlarmStatus
chRPMMinorAlarmStatus
chAlarmRpmUp
chAlarmRpmDown
chSysCardOperStatus
chAlarmCardDown
chAlarmCardUp
chAlarmCardReset
chAlarmCardProblem
chAlarmCardMismatch
chAlarmCardRemove
Description
Fault status of the major alarm LED on the RPM
Fault status of the minor alarm LED on the RPM
Trap generated when the status of primary or
secondary RPM changes to up and running
Trap generated when the status of primary or
secondary RPM changes to down, either by
software reset or by being physically removed from
the chassis
Operational status of the card.
• If the chSysCardAdminStatus is up, the valid
state is ready—the card is present and ready and
the chSysCardOperStatus status is up.
• If the chSysCardAdminStatus is down the
service states can be:
• offline: the card is not used.
• cardNotmatch: the card does not
match what is configured
• cardProblem: a hardware
problem has been detected on the
card.
• diagMode: the card is in the
diagnostic mode.
Note: chSysCardFaultStatus is supported only the
C-Series.
Trap reported when a card operational status
changes to down
Trap reported when a card operational status
changes to up
Trap reported when a card is reset
Trap reported when a card operational status
changes to card problem
Trap generated when the configured card does not
match the installed card
Trap generated when a card is removed