Additional Policy Configurations; Ftsa Policy Sample Configurations - Dell Force10 C150 Configuration Manual

Additional Policy Configurations

Task
Associate a Dell Force10 TAC case number with the
policy. Configure a case number only if you already
have a case open with Dell Force10 for the policy. This
case number is included in action-list messages sent to
Dell Force10.
Delay the subsequent execution of the test list after a
match occurs. This configuration reduces the risk of
burdening the CPU with sampling when a failure
condition has already been detected.
Default: 5 minutes
Associate a Dell Force10 Problem Report (PR) number
with the policy. Configure a PR number only if you
already have a case open with Dell Force10 for the
policy. This PR number is included in action-list
messages sent to Dell Force10.
Execute the action list contingent upon the state of CPU
utilization. The CPU utilization is calculated in
percentage using the 1 minute rolling average of all
RPM CPUs.
Default: unconditional
Note: If a test-list match is found, but the action-list does not execute because the
exists, then FTSA logs the test-list match and indicates that the action-list was prevented. However, if the trigger
event was a high or specified CPU usage condition in the test-list, then the FTSA ignores the
configuration.
Specify the interval at which the system variables
specified in the test-list are sampled.
Default: 1 minute
Execute the test list multiple times. If the test limit is
greater than 1, the test list is executed immediately after
the previous execution is complete.
Default: unlimited

FTSA Policy Sample Configurations

Line card state-change policy configuration
The following FTSA policy configuration uses the default test list hardware, which contains a
line-card-state-change condition, and the default action list hardware plus the custom action show linecard
4 | grep Status. Linecard 4 is then taken offline to trigger a match against the card-state-change test
condition.
364 | Force10 Service Agent
Command
case-number number
dampen minutes
pr-number number
run-cpu cp slot | any} |
{ cpu | {
rpm-any {{less-than |
}
greater-than
}
percentage
sample-rate
test-limit
Command Mode
CALLHOME POLICY
CALLHOME POLICY
CALLHOME POLICY
CALLHOME POLICY
condition is
run-cpu less-than
run-cpu less-than
CALLHOME POLICY
CALLHOME POLICY