Dell Force10 C150 Configuration Manual page 294

• The IPv4Flow configuration is applied to entire system when you enter the command
from CONFIGURATION mode, however, you must save the running-configuration to affect the
change.
The amount of space that is allocated among the sub-partitions must be equal to the amount of CAM space
allocated to IPv4Flow by the selected CAM profile (see
allocated space is not correct.
Message 3 IPv4Flow Configuration Error
% Error: Total size must add up to match IPv4flow size of 24K required by the configured
profile.
The minimum amount of space that can be allocated to any sub-partition is 1K, except for System flow, for
which the minimum is 4K.
To re-allocate CAM space within the IPv4Flow partition on the entire system:
Step Task
1 Re-allocate CAM space within the
IPv4Flow partition.
2 Save the running-configuration.
3 Verify that the new CAM configuration will
be written to the CAM on the next boot.
4 Reload the system.
294 | Content Addressable Memory
Table 11-1.);
Command Syntax
cam-ipv4flow
copy running-config
startup-config
show cam-ipv4flow
reload
cam-ipv4flow
Message 3 is displayed if the total
Command Mode
CONFIGURATION
EXEC Privilege
EXEC Privilege
EXEC Privilege