Qos Rate Adjustment - Dell Force10 C150 Configuration Manual

Specify an aggregate QoS policy
Specify an aggregate QoS policy using the command
Apply an output policy map to an interface
Apply an input policy map to an interface using the command
mode. You can apply the same policy map to multiple interfaces, and you can modify a policy map after
you apply it.

QoS Rate Adjustment

The Ethernet packet format consists of:
• Preamble: 7 bytes Preamble
• Start Frame Delimiter (SFD): 1 byte
• Destination MAC Address: 6 bytes
• Source MAC Address: 6 bytes
• Ethernet Type/Length: 2 bytes
• Payload: (variable)
• Cyclic Redundancy Check (CRC): 4 bytes
• Inter-frame Gap (IFG): (variable)
By default, while rate limiting, policing, and shaping, FTOS does not include the Preamble, SFD, or the
IFG fields. These fields are overhead; only the fields from MAC Destination Address to the CRC are used
for forwarding and are included in these rate metering calculations. You can optionally include overhead
fields in rate metering calculations by enabling QoS Rate Adjustment.
QoS Rate Adjustment is disabled by default, and no
Task
Include a specified number of bytes of packet overhead
to include in rate limiting, policing, and shaping
calculations. For example, to include the Preamble and
qos-rate-adjust
SFD, enter
overhead fields you must know the number of bytes you
want to include.
8. For variable length
policy-aggregate
service-policy output
qos-rate-adjust
is listed in the running-configuration.
Command Syntax
qos-rate-adjust overhead-bytes
Default: Disabled
C-Series and S-Series Range: 1-31
E-Series Range: 1-144
from POLICY-MAP-OUT mode.
from INTERFACE
Command Mode
CONFIGURATION
Quality of Service | 869