Show The Running-Configuration For An Interface; Clear Ipv6 Routes - Dell Force10 C150 Configuration Manual

Show the Running-Configuration for an Interface

View the configuration for any interface with the following command.
Command Syntax
show running-config
interface
type {slot/port}
Figure 22-10
Figure 22-10. Command Example:
FTOS#show run int gi 2/2
!
interface GigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
FTOS#

Clear IPv6 Routes

Use the clear IPv6 route command to clear routes from the IPv6 routing table.
Command Syntax
clear ipv6 route
{
}
prefix-length
504 | IPv6 Addressing
Command Mode
EXEC
show running-config
illustrates the
Command Mode
*
| ipv6 address EXEC
Purpose
Show the currently running configuration for the
specified interface
Enter the keyword
interface and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the
keyword
port information.
• For a Gigabit Ethernet interface, enter the
keyword
port information.
• For the Management interface on the RPM, enter
the keyword
the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword
slot/port information.
command output. Note the IPv6 address listed.
show running-config interface
Purpose
Clear (refresh) all or a specific routes from the IPv6
routing table.
* : all routes
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
interface
followed by the type of
GigabitEthernet
followed by the slot/
GigabitEthernet
followed by the slot/
ManagementEthernet
followed by
TenGigabitEthernet
followed by the