Dell Force10 C150 Configuration Manual page 228

show config
Enter
show ip bgp summary
the summary with a 2-Byte AS Number displayed;
Number displayed.
Figure 10-12. Command example: show ip bgp summary (2-Byte AS Number displayed)
R2#show ip bgp summary
BGP router identifier 192.168.10.2, local AS number 65123
BGP table version is 1, main routing table version 1
1 network entrie(s) using 132 bytes of memory
1 paths using 72 bytes of memory
BGP-RIB over all using 73 bytes of memory
1 BGP path attribute entrie(s) using 72 bytes of memory
1 BGP AS-PATH entrie(s) using 47 bytes of memory
5 neighbor(s) using 23520 bytes of memory
Neighbor
10.10.21.1
10.10.32.3
100.10.92.9
192.168.10.1
192.168.12.2
R2#
Figure 10-13. Command example: show ip bgp summary (4-Byte AS Number displayed)
R2#show ip bgp summary
BGP router identifier 192.168.10.2, local AS number 48735.59224
BGP table version is 1, main routing table version 1
1 network entrie(s) using 132 bytes of memory
1 paths using 72 bytes of memory
BGP-RIB over all using 73 bytes of memory
1 BGP path attribute entrie(s) using 72 bytes of memory
1 BGP AS-PATH entrie(s) using 47 bytes of memory
5 neighbor(s) using 23520 bytes of memory
Neighbor
10.10.21.1
10.10.32.3
100.10.92.9
192.168.10.1
192.168.12.2
R2#
For the router's identifier, FTOS uses the highest IP address of the Loopback interfaces configured. Since
Loopback interfaces are virtual, they cannot go down, thus preventing changes in the router ID. If no
Loopback interfaces are configured, the highest IP address of any interface is used as the router ID.
To view the status of BGP neighbors, use the
Privilege mode. For BGP neighbor configuration information, use the
command in EXEC Privilege mode
CONFIGURATION ROUTER BGP mode gives the same information as thew
228 | Border Gateway Protocol IPv4 (BGPv4)
in CONFIGURATION ROUTER BGP mode to view the BGP configuration. Use the
command in EXEC Privilege mode to view the BGP status.
AS MsgRcvd
65123 0
65123 0
65192 0
65123 0
65123 0
AS MsgRcvd
65123 0
65123 0
65192 0
65123 0
65123 0
(Figure
Figure 10-13 shows the summary with a 4-Byte AS
MsgSent TblVer InQ
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
MsgSent TblVer InQ
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
show ip bgp neighbors
showconfig
10-15). Note that the
Figure 10-12
2-Byte AS Number
OutQ Up/Down State/Pfx
0 never Active
0 never Active
0 never Active
0 never Active
0 never Active
4-Byte AS Number
OutQ Up/Down State/Pfx
0 never Active
0 never Active
0 never Active
0 never Active
0 never Active
(Figure 10-14) command in EXEC
show running-config bgp
command in
show running-config bgp
shows
.