Dell Force10 C150 Configuration Manual page 1159

Run an FTOS XML session
Use the following procedure to start, run, and close an FTOS XML session:
Step Command Syntax
terminal xml
1
2 [Construct input to the CLI by
following the XML request schema,
as described in The Form of XML
Requests and Responses on
page 1156.]
3 Press Ctrl-Y (or press Enter twice,
creating an empty line).
Press Ctrl-Z (or enter terminal no
4
xml as the <command> string in the
XML request <action> schema).
Figure 59-1, below, illustrates entering FTOS XML mode.
full sequence of invoking an XML session, entering a command, receiving a success response, and leaving
the session with the
Figure 59-1. Example of Entering FTOS XML mode from the CL
FTOS# terminal xml
FTOS(xml)#
Enter XML request with CTRL-Y or empty line
Clear XML request with CTRL-C
Exit XML mode with CTRL-Z:
Command Mode
EXEC Privilege
FTOS XML
FTOS XML
FTOS XML
terminal no xml
command in XML:
Purpose
Invoke XML interface in Telnet and SSH client
sessions.
Cut and paste your XML request from a text editor
or other type of XML presentation tool, or type your
XML request line by line.
Execute the request.
Alternatively, to cancel the request (only possible
before sending) and get a fresh XML prompt, press
Ctrl-C.
Exit from FTOS XML mode.
Figure 59-1 on page 1159, below, illustrates the
FTOS XML Feature | 1159