Dell Force10 C150 Configuration Manual page 888

Figure 42-10. Using show ip route Command to Show RIP Configuration on Core 2
Core2#show ip route
Codes: C - connected, S - static, R - RIP,
Gateway of last resort is not set
Destination
C
C
R
C
C
R
R
Core2#
R
R
Core2#
Figure 42-11. Using show ip protocols Command to Show RIP Configuration Activity on Core 2
Core2#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 17
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is
Default version control: receive version 2, send version 2
Routing for Networks:
Routing Information Sources:
Gateway
10.11.20.1
Distance: (default is 120)
Core2#
888 | Routing Information Protocol
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway
----------- -------
10.11.10.0/24 Direct, Gi 2/11
10.11.20.0/24 Direct, Gi 2/31
10.11.30.0/24 via 10.11.20.1, Gi 2/31
10.200.10.0/24 Direct, Gi 2/41
10.300.10.0/24 Direct, Gi 2/42
192.168.1.0/24 via 10.11.20.1, Gi 2/31
192.168.2.0/24 via 10.11.20.1, Gi 2/31
192.168.1.0/24 via 10.11.20.1, Gi 2/31
192.168.2.0/24 via 10.11.20.1, Gi 2/31
Interface Recv
GigabitEthernet 2/42
GigabitEthernet 2/41
GigabitEthernet 2/31
GigabitEthernet 2/11
10.300.10.0
10.200.10.0
10.11.20.0
10.11.10.0
Distance
120
Dist/Metric Last Change
1
Send
2 2
2 2
2 2
2 2
Last Update
00:00:12
----------- -----------
0/0 00:02:26
0/0 00:02:02
120/1 00:01:20
0/0 00:03:03
0/0 00:02:42
120/1 00:01:20
120/1 00:01:20
120/1 00:05:22
120/1 00:05:22