Dell Force10 C150 Configuration Manual page 229

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Figure 10-14
displays two neighbors, one is an external and the second one is an internal BGP neighbor.
The first line of the output for each neighbor displays the AS number and states whether the link is an
external or internal.
show ip bgp neighbors
The third line of the
ESTABLISHED is listed, the neighbor is not exchanging information and routes. For more details on using
show ip bgp neighbors
the
Figure 10-14. Command example: show ip bgp neighbors
FTOS#show ip bgp neighbors
BGP neighbor is 10.114.8.60, remote AS 18508, external link
BGP version 4, remote router ID 10.20.20.20
BGP state ESTABLISHED, in this state for 00:01:58
Last read 00:00:14, hold time is 90, keepalive interval is 30 seconds
Received 18552 messages, 0 notifications, 0 in queue
Sent 11568 messages, 0 notifications, 0 in queue
Received 18549 updates, Sent 11562 updates
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP table version 216613, neighbor version 201190
130195 accepted prefixes consume 520780 bytes
Prefix advertised 49304, rejected 0, withdrawn 36143
Connections established 1; dropped 0
Last reset never
Local host: 10.114.8.39, Local port: 1037
Foreign host: 10.114.8.60, Foreign port: 179
BGP neighbor is 10.1.1.1, remote AS 65535, internal link
Administratively shut down
BGP version 4, remote router ID 10.0.0.0
BGP state IDLE, in this state for 17:12:40
Last read 17:12:40, hold time is 180, keepalive interval is 60 seconds
Received 0 messages, 0 notifications, 0 in queue
Sent 0 messages, 0 notifications, 0 in queue
Received 0 updates, Sent 0 updates
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP table version 0, neighbor version 0
0 accepted prefixes consume 0 bytes
Prefix advertised 0, rejected 0, withdrawn 0
Connections established 0; dropped 0
Last reset never
No active TCP connection
FTOS#
output contains the BGP State. If anything other than
command, refer to the
FTOS Command Line Interface Reference
External BGP neighbor
Internal BGP neighbor
Border Gateway Protocol IPv4 (BGPv4) | 229
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents