Dell Force10 C150 Configuration Manual page 359

Table 16-1. Pre-defined Policy Test Lists
Condition Conditions Tested
Hardware Status
Hardware
SFM status transition from active to another state
RPM status transition from active to another state
Line Card transition from active to another state
Port-pipe error or transition to down
PEM transition from up to another state
AC PSU transition from up to other state
Fan Tray down or individual fan down
Environmental status
Overtemp for each item listed in
Over/under-voltage for each item listed in
Software SWP Timeout, IPC Timeout, IRC timeout, CPU > 85%, Memory usage > 85%
To add a pre-defined list of conditions to your policy test list:
Task
Add a pre-defined list of conditions to
your policy test list.
Table 16-2 shows the test conditions that are available to add to a custom policy test list. See the Dell
Force10 MIB for further description of the given Object Identifiers (OID). You may only specify one test
condition within a policy.
Table 16-2. Custom Policy Test Conditions
Condition Keyword
cpu-1-min
CPU Usage
cpu-5-min
interface-bit-rate
Interface Rate/
Throttles
interface-rate
interface-throttles
interface-crc
Interface
Errors
show environment
show environment
Command
default-test [ exception | hardware |
software ]
Description
CPU utilization in percentage for the
last 1 minute.
CPU utilization in percentage for the
last 5 minutes.
Interface bandwidth in bits/second.
Interface bandwidth in packets/
second.
The total number of valid ingress
frames with a length or type field
value equal to 0x8808 (Control
Frame).
Frames received with a length
between 64 and 1518 octets,
inclusive, that had an incorrect CRC.
Command Mode
CALLHOME TESTLIST
OID
chRpmCpuUtil1Min
chRpmCpuUtil5Min
f10IfInThrottles
f10IfOutThrottles
f10IfInCRC
Force10 Service Agent | 359