Choose An Interface-Range Macro; Monitor And Maintain Interfaces - Dell Force10 C150 Configuration Manual

Choose an Interface-range Macro

To use an interface-range macro in the
Command Syntax
interface range macro name
The example below shows how to change to the interface-range configuration mode using the
interface-range macro named "test".
FTOS(config)# interface range macro test
FTOS(config-if)#

Monitor and Maintain Interfaces

Monitor interface statistics with the
the interface status (up/down), number of packets, traffic statistics, etc.
Command Syntax
monitor interface interface
The information
the following keys to manage the output.
m - Change mode
l - Page up
T - Increase refresh interval (by 1 second)
q - Quit
444 | Interfaces
interface range
Command Mode
CONFIGURATION
monitor interface
Command Mode
EXEC Privilege
(Figure 20-27) displays in a continuous run, refreshing every 2 seconds by default. Use
command, enter this command:
Purpose
Selects the interfaces range to be configured using the values
saved in a named interface-range macro.
command. This command displays an ongoing list of
Purpose
View the interface's statistics. Enter the type of interface and
slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface on the RPM, enter the
keyword ManagementEthernet followed by the slot/
port information.
For a SONET interface, enter the keyword sonet
•
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
c - Clear screen
a - Page down
t - Decrease refresh interval (by 1 second)