Display Default And Configured Wred Profiles; Display Wred Drop Statistics - Dell Force10 C150 Configuration Manual

WRED can be used in combination with storm control to regulate broadcast and unknown-unicast traffic.
This feature is available through an additional option in command
unknown-unicast
using this command.
Using the command
broadcast traffic can consume is reduced to 50% of line rate. Even though broadcast traffic is restricted, the
rate of outgoing broadcast traffic might be greater than other traffic, and if so, broadcast packets would
consume too much buffer space. So, the
that broadcast traffic can consume.

Display Default and Configured WRED Profiles

Display default and configured WRED profiles and their threshold values using the command
wred-profile
Figure 41-14. Displaying WRED Profiles
FTOS#show qos wred-profile
Wred-profile-name
wred_drop
wred_ge_y
wred_ge_g
wred_teng_y
wred_teng_g

Display WRED Drop Statistics

Display the number of packets FTOS dropped by WRED Profile using the command
from EXEC Privilege mode, as shown in
872 | Quality of Service
] at CONFIGURATION. See the FTOS Command Line Reference for information on
storm-control broadcast 50 out wred-profile
from EXEC mode, as shown in
min-threshold
0
1000
2000
4000
8000
, for example, first the total bandwidth that
wred-profile
option is added to limit the amount of buffer space
Figure 41-14.
max-threshold
0
2000
4000
8000
16000
Figure 41-15.
storm-control broadcast
[
show qos statistics
|
show qos