Allocating Bandwidth To Multicast Queues - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Figure 41-15. show qos statistics Command Example
FTOS#show qos statistics wred-profile
Interface Gi 5/11
Queue#
Drop-statistic
0
Green
Yellow
Out of Profile
1
Green
Yellow
Out of Profile
2
Green
Yellow
Out of Profile
3
Green
Yellow
Out of Profile
4
Green
Yellow
Out of Profile
5
Green
Yellow
Out of Profile
6
Green
Yellow
Out of Profile
7
Green
Yellow
Out of Profile
FTOS#
FTOS Behavior: The C-Series fetches the per-queue packet count via class-maps. The count is the
number of packets matching the ACL entries in class-map. Every time the class-map or policy-map is
modified, the ACL entries are re-written to the Forwarding Processor, and the queue statistics are
cleared. This behavior is different from the E-Series. The E-Series fetches the packet count directly
from counters at each queue, which allows queue statistics to persist until explicitly cleared via the CLI.

Allocating Bandwidth to Multicast Queues

Allocating Bandwidth to Multicast Queues
The E-Series has 128 multicast queues per port-pipe, which are transparent, and eight unicast queues per
port. You can allocate a specific bandwidth percentage per port-pipe to multicast traffic using the
queue egress multicast bandwidth-percentage
command
If you configure
multicast, and the remaining bandwidth is distributed based on your configuration.
If you configure multicast bandwidth, after assigning the specified amount of bandwidth to multicast
the remaining bandwidth is distributed according to the WFQ algorithm.
If you configure
based on your configuration for multicast then unicast (based on the remaining available bandwidth),
and the remaining bandwidth is distributed among the other queues.
WRED-name
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
WRED1
WRED2
is supported on platform:
bandwidth-percentage
for unicast only, 1/8 of the port bandwidth is reserved for
bandwidth-percentage
for both unicast and multicast, then bandwidth is assigned
Min
Max
Dropped Pkts
10
100
51623
20
100
51300
0
10
100
52082
20
100
51004
0
10
100
50567
20
100
49965
0
10
100
50477
20
100
49815
0
10
100
50695
20
100
49476
0
10
100
50245
20
100
49535
0
10
100
50033
20
100
49595
0
10
100
50474
20
100
49522
0
e
from CONFIGURATION mode.
Quality of Service | 873

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents