Configuring An Archive File Maximum - Dell Force10 C150 Configuration Manual

Figure 12-5. Configuring FTOS to Rollback to a Previous Configuration
FTOS#configure replace archive_0 time ?
<60-1800>
FTOS#configure replace archive_0 time 60
This will apply all nessesary additions and deletions
to replace the current running-config with the contents
of the specified configuration file,
which is assumed to be complete configuration,
not a partial configuration
Please confirm if you want to proceed [yes/no]:yes
3d4h45m: %RPM0-P:CP %CLI-6-RBACKSTART: start rollback to file flash:/CFGARCH_DIR/archive_0
3d4h45m: %RPM0-P:CP %SYS-5-CONFIG_LOAD: Loading configuration file
3d4h45m: %RPM0-P:CP %CLI-6-RBACKCOMPLETE: completed rollback to flash:/CFGARCH_DIR/archive_0
R1#
R1#Warning: time is expired before confirm. Replace with flash://CFGARCH_DIR/archive_1
FTOS#
Figure 12-6. Committing to an Archived Configuration
FTOS#config replace archive_0 time 60
This will apply all nessesary additions and deletions
to replace the current running-config with the contents
of the specified configuration file,
which is assumed to be complete configuration,
not a partial configuration
Please confirm if you want to proceed [yes/no]:yes
3d5h26m: %RPM0-P:CP %CLI-6-RBACKSTART: start rollback to file flash:/CFGARCH_DIR/archive_0
3d5h26m: %RPM0-P:CP %SYS-5-CONFIG_LOAD: Loading configuration file
3d5h26m: %RPM0-P:CP %CLI-6-RBACKCOMPLETE: completed rollback to flash:/CFGARCH_DIR/archive_0
R1#configure confirm

Configuring an Archive File Maximum

The maximum number of archive files is configurable between 2 and 15. Default maximum is 10. Use the
maximum
command
• If you attempt to archive more configurations than the maximum allowed, the oldest archived
configuration is deleted
archived file is still incremented (up to 14, after which the numbering convention restarts at 0; if
present, archive_0 is overwritten).
• If you configure a maximum less than the number of archived files you already have, then archived
files are deleted to satisfy the maximum.
Figure 12-7. Configuring an Archive Maximum
R1(conf-archive)#maximum 2
R1(conf-archive)#show config
!
archive
maximum 2
R1(conf-archive)#
Time value (in seconds)
from ARCHIVE mode to configure this parameter, as shown in
(Figure 12-8) to create space. However, the number in the name of the
Figure 12-7.
Configuration Replace and Rollback | 305