Dell Force10 C150 Configuration Manual page 947

Figure 45-14. Trace List Example
FTOS(config-trace-acl)#deny tcp host 123.55.34.0 any
FTOS(config-trace-acl)#permit udp 154.44.123.34 0.0.255.255 host 34.6.0.0
FTOS(config-trace-acl)#show config
!
ip trace-list nimule
seq 5 deny tcp host 123.55.34.0 any
seq 10 permit udp 154.44.0.0 0.0.255.255 host 34.6.0.0
To view all configured Trace lists and the number of packets processed through the Trace list, use the
ip accounting trace-list
Apply trace lists
After you create a Trace list, you must enable it. Without enabling the Trace list, no traffic is filtered.
You can enable one Trace list.
To enable a Trace list, use the following command in the CONFIGURATION mode:
Command Syntax
ip trace-group trace-list-name
To remove a Trace list, use the
Once the Trace list is enabled, you can view its log with the
linecard number
[ ] command.
Figure 45-15. show ip accounting trace-list Command Example
FTOS#show ip accounting trace-list dilling
Trace List dilling on linecard 0
seq 2 permit ip host 10.1.0.0 any count (0 packets)
seq 5 deny ip any any
FTOS#
command (Figure 110)
Command Mode
CONFIGURATION
no ip trace-group trace-list-name
in the EXEC Privilege mode.
Purpose
Enable a configured Trace list to filter traffic.
command syntax.
show ip accounting trace-list trace-list-name
show
Security | 947