Manual Reload Messages - Dell Force10 C150 Configuration Manual

To manually write the contents of an RPM log to the internal flash:
Task
Write the RPM trace log to flash.
To manually write the contents of a line card log to the internal flash:
Task
Write the line card trace log to flash.
Figure 60-7.
TRACE_CURR_BOOT
FTOS#cd /flash/TRACE_LOG_DIR/TRACE_CURR_BOOT
FTOS#dir
hw_traceLP0.0
hw_traceLP0.1
hw_traceLP2.0
Disable writing the contents of a hardware log to the internal the flash:
Task
Stop the writing the hardware log to flash.
View the hardware log contents or clear them with the following commands.:
Task
View the content of the hardware log.
Clear the hardware log buffer

Manual reload messages

When the chassis is reloaded manually (through the CLI), trace messages in all of the buffers (software and
hardware) in CP and linecards are saved to the flash as reload_traceRPM0_CP and reload_traceLP1 in
flash:/TRACE_LOG_DIR/TRACE_CURR_BOOT
TRACE_LOG_DIR/TRACE_LAST_BOOT
Command Syntax
upload trace-log cp
]
Command Syntax
upload trace-log linecard
sw-traceupload trace-log cp
sw-trace ]
Directory example
hw_traceLP2.1 hw_traceLP2.4
hw_traceLP2.2 hw_traceRPM0_CP.0
hw_traceLP2.3 hw_traceRPM0_CP.1
Command Syntax
trace disable
Command Syntax
show trace hardware
clear trace hardware
. After reload, you can see these files in
.
[cmd-history | hw-trace | sw-trace
| [hw-trace |
[0-7]
| [cmd-history | hw-trace |
hw_traceRPM0_CP.2
hw_traceRPM0_CP.3
hw_traceRPM0_CP.4
slot-number
C-Series Debugging and Diagnostics | 1177
Command Mode
EXEC Privilege
Command Mode
EXEC Privilege
Command Mode
EXEC Privilege
Command Mode
EXEC Privilege
EXEC Privilege
flash:/