Sample Configurations; Vrrp For Ipv4 Configuration - Dell Force10 C150 Configuration Manual

Sample Configurations

VRRP for IPv4 Configuration

The configuration in
comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You
can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your
own IP addresses, interfaces, names, etc.
configuration in
Figure 58-21. VRRP for IPv4 Topology
State Master: R2 interface has the
higher VRRP group priority (200)
Virtual MAC is automatically
assigned and is the same on
both Routers
State Backup: R3 interface has the
lower VRRP group priority (100)
10.1.1.1
GigE 2/31
1144 | Virtual Router Redundancy Protocol (VRRP)
Figure 58-21 shows how to enable IPv4 VRRP. This example does not contain
Figure 58-22.
R2#show vrrp
------------------
GigabitEthernet 2/31, VRID: 99, Net: 10.1.1.1
State: Master, Priority: 200, Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 661, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:63
Virtual IP address:
10.1.1.3
Authentication: (none)
R2#
R3#show vrrp
------------------
GigabitEthernet 3/21, VRID: 99, Net: 10.1.1.2
State: Backup, Priority: 100, Master: 10.1.1.1
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 331, Bad pkts rcvd: 0, Adv sent: 0, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:63
Virtual IP address:
10.1.1.3
Authentication: (none)
R3#
R2
VRID 99
Figure 58-21 shows the VRRP topology created with the CLI
10.1.1.3
Internet
10.1.1.2
GigE 3/21
R3