Dell Force10 C150 Configuration Manual page 666

Limit the Number of Multicast Routes
Task
Limit the total number of multicast routes on the system.
When the limit is reached, FTOS does not process any IGMP or MLD joins to PIM—though it still
processes leave messages—until the number of entries decreases below 95% of the limit. When the limit
falls below 95% after hitting the maximum, the system begins relearning route entries through IGMP,
MLD, and MSDP.
• If the limit is increased after it is reached, join subsequent join requests are accepted. In this case, you
must increase the limit by at least 10% for IGMP and MLD to resume.
• If the limit is decreased after it is reached, FTOS does not clear the existing sessions. Entries are
cleared upon a timeout (you may also clear entries using
Note: FTOS waits at least 30 seconds between stopping and starting IGMP join processing. You may
experience this delay when manipulating the limit after it is reached.
When the multicast route limit is reached, FTOS displays
Message 1 Multicast Route Limit Error
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB limit reached. No new routes will be
learnt until TIB level falls below low watermark.
3w1d13h: %RPM0-P:RP2 %PIM-3-PIM_TIB_LIMIT: PIM TIB below low watermark. Route learning will
begin.
Note: The IN-L3-McastFib CAM partition is used to store multicast routes and is a separate hardware limit
that is exists per port-pipe. Any software-configured limit might be superseded by this hardware space
limitation. The opposite is also true, the CAM partition might not be exhausted at the time the system-wide
route limit set by the
666 | Multicast Features
is reached.
ip multicast-limit
Command Syntax
ip multicast-limit
Range: 1-50000
Default: 15000
clear ip mroute
Message 1.
Command Mode
CONFIGURATION
).