Rip Configuration On Core 3; Core 3 Rip Output - Dell Force10 C150 Configuration Manual

RIP Configuration on Core 3

Figure 42-12. RIP Configuration on Core 3
Core3(conf-if-gi-3/21)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
router rip
network 10.0.0.0
network 192.168.1.0
network 192.168.2.0
version 2
Core3(conf-router_rip)#

Core 3 RIP Output

The screenshots in this section are:
• Figure 42-13: Using
• Figure 42-14: Using
• Figure 42-15: Using
Figure 42-13. Using show ip rip database Command for Core 3 RIP Setup
Core3#show ip rip database
Total number of routes in RIP database: 7
10.11.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.200.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.300.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.11.20.0/24
10.11.30.0/24
10.0.0.0/8
192.168.1.0/24
192.168.1.0/24
192.168.2.0/24
192.168.2.0/24
Core3#
show ip rip database
command to display Core 3 RIP database
show ip route
command to display Core 3 RIP setup
show ip protocols
command to display Core 3 RIP activity
directly connected,GigabitEthernet 3/21
directly connected,GigabitEthernet 3/11
auto-summary
directly connected,GigabitEthernet 3/43
auto-summary
directly connected,GigabitEthernet 3/44
auto-summary
Routing Information Protocol | 889