Configure A Source Ip Address For Ntp Packets - Dell Force10 C150 Configuration Manual

To disable NTP on an interface, use the following command in the INTERFACE mode:
Command Syntax
ntp disable
To view whether NTP is configured on the interface, use the
mode. If
config
command displays only non-default configuration information.)

Configure a source IP address for NTP packets

By default, the source address of NTP packets is the IP address of the interface used to reach the network.
You can configure one interface's IP address to be included in all NTP packets.
To configure an IP address as the source address of NTP packets, use the following command in the
CONFIGURATION mode:
Command Syntax
ntp source
interface
To view the configuration, use the
mode.
1074 | System Time and Date
ntp disable
is not listed in the
Command Mode
CONFIGURATION
Command Mode
INTERFACE
show config
command output, then NTP is enabled. (The
Purpose
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a loopback interface, enter the keyword loopback followed by
•
a number between 0 and 16383.
For a port channel interface, enter the keyword lag followed by a
•
number from 1 to 255 for TeraScale and ExaScale, 1 to 32 for
EtherScale.
• For a SONET interface, enter the keyword
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
For a VLAN interface, enter the keyword vlan followed by a
•
number from 1 to 4094.
E-Series ExaScale platforms support 4094 VLANs with FTOS
version 8.2.1.0 and later. Earlier ExaScale supports 2094
VLANS.
show running-config ntp
Purpose
Disable NTP on the interface.
show config
command in the INTERFACE
sonet
command (Figure 38) in the EXEC privilege
show
followed by the