Ipv6 Routes - Dell Force10 C150 Configuration Manual

Command Syntax
distribute-list
prefix-list-name
| connected | ospf
as-number
static ]
distribute-list redistributed-override in

IPv6 routes

Use these commands in ADDRESS-FAMILY IPV6 mode to apply prefix lists to incoming or outgoing
IPv6 routes. =
Note:
These commands apply to IPv6 IS-IS only. Use the
prefix lists to IPv4 routes.
Command Syntax
distribute-list
prefix-list-name
526 | Intermediate System to Intermediate System
Command Mode
out [ bgp
ROUTER ISIS
| rip |
process-id
ROUTER ISIS
Command Mode
in [
] ROUTER ISIS-AF
interface
IPV6
Purpose
Apply a configured prefix list to all outgoing
IPv4 IS-IS routes. You can configure one of
the optional parameters:
connected: for directly connected routes.
•
ospf
• for OSPF routes only.
process-id:
rip: for RIP routes only.
•
static: for user-configured routes.
•
bgp : for BGP routes only
•
Deny RTM download for pre-existing
redistributed IPv4 routes
ROUTER ISIS
mode previously shown to apply
Purpose
Apply a configured prefix list to all incoming
IPv6 IS-IS routes.
Enter the type of interface and slot/port
information:
• For a 1-Gigabit Ethernet interface, enter
the keyword GigabitEthernet followed
by the slot/port information.
• For the Loopback interface on the RPM,
enter the keyword loopback followed by
a number from 0 to 16383.
• For a port channel, enter the keyword
port-channel followed by a number from
1 to 255 for TeraScale, 1 to 32 for
EtherScale.
• For a SONET interface, enter the keyword
sonet followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter
the keyword TenGigabitEthernet
followed by the slot/port information.
For a VLAN, enter the keyword vlan
•
followed by a number from 1 to 4094.
E-Series ExaScale platforms support
4094 VLANs with FTOS version
8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.