Dell Force10 C150 Configuration Manual page 882

To add routes from other routing instances or protocols, use any of the following commands in the
ROUTER RIP mode:
Command Syntax
redistribute { connected | static } [ metric
] [ route-map
metric-value
redistribute isis [ level-1 | level-1-2 | level-2 ]
[ metric
metric-value
redistribute ospf
2 } | match internal ] [ metric
map-name ]
To view the current RIP configuration, use the
show config
Set send and receive version
To specify the RIP version, use the
receive only one or the other version, use the
in the INTERFACE mode.
To change the RIP version globally in FTOS, use the following command in the ROUTER RIP mode:
Command Syntax
version { 1 | 2 }
You can set one RIP version globally on the
the interfaces participating in RIP unless the interface was specifically configured for a specific RIP
version.
show config
Use the
configured. You can also use the
protocols configuration.
882 | Routing Information Protocol
map-name ]
] [ route-map
map-name ]
[ match external { 1 |
process-id
] [ route-map
value
command in the ROUTER RIP mode.
version
command in the ROUTER RIP mode to see whether the
show ip protocols
Command Mode
ROUTER RIP
ROUTER RIP
ROUTER RIP
show running-config
command in the ROUTER RIP mode. To set an interface to
ip rip send version
Command Mode Purpose
ROUTER RIP Set the RIP version sent and received on the system.
system
. This command sets the RIP version for RIP traffic on
command in the EXEC mode to view the routing
Purpose
Include directly connected or
user-configured (static) routes in RIP.
• metric range: 0 to 16
• map-name : name of a configured route
map.
Include IS-IS routes in RIP.
• range: 0 to 16
metric
• : name of a configured route
map-name
map.
Note: IS-IS is not supported on the
S-Series platform.
Include specific OSPF routes in RIP.
Configure the following parameters:
• range: 1 to 65535
process-id
• range: 0 to 16
metric
• map-name : name of a configured route
map.
command in the EXEC mode or the
ip rip receive version
or the
version
command is
commands