Recover From A Card Problem State On An S-Series Stack; Recover From A Card Mismatch State On An S-Series Stack - Dell Force10 C150 Configuration Manual

Figure 50-21. Recovering from a Stack Link Flapping Error
--------------------------------------MANAGMENT UNIT-----------------------------------------
Error: Stack Port 50 has flapped 5 times within 10
ack port now.
Error: Please check the stack cable/module and power-cycle the stack.
10:55:20: %STKUNIT1-M:CP
ithin 10 seconds.Shutting down this stack port now.
10:55:20: %STKUNIT1-M:CP %KERN-2-INT: Error: Please check the stack cable/module
and power-cycle the stack.
---------------------------------------STANDBY UNIT------------------------------------------
10:55:18: %STKUNIT1-M:CP %KERN-2-INT: Error: Stack Port 50 has flapped 5 times within 10
seonds.Shutting down this stack port now.
10:55:18: %STKUNIT1-M:CP %KERN-2-INT: Error: Please check the stack cable/module
and power-cycle the stack.
----------------------------------------MEMBER 2---------------------------------------------
Error: Stack Port 51 has flapped 5 times within 10 seconds.Shutting down this stack port now.
Error: Please check the stack cable/module and power-cycle the stack.

Recover from a Card Problem State on an S-Series Stack

If a unit added to a stack has a different FTOS version, the unit does not come online, and FTOS cites a
card problem error, as shown in
the FTOS version to match the stack, and then reconnect it to the stack.
Figure 50-22. Recovering from a Card Problem Error on an S-Series Stack
F
Stack#show system brief
Stack MAC : 00:01:e8:d5:f9:6f
-- Stack Info --
Unit UnitType Status
---------------------------------------------------------------------------
0 Member card problem
1 Management online
2 Standby online
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present

Recover from a Card Mismatch State on an S-Series Stack

A card mismatch occurs if the stack has a provision for the lowest available stack number which does not
match the model of a newly added unit
• remove the provision from the stack, then reconnect the standalone unit, or
• renumber the standalone unit with another available stack number on the stack.
%KERN-2-INT: Error: Stack Port 50 has flapped 5 times w
Figure 50-22. To recover, disconnect the new unit from the stack, change
ReqTyp CurTyp
S25N unknown
S50N S50N
S50V S50V
(Figure 50-23). To recover, disconnect the new unit. Then, either:
seconds.Shutting down this st
Version Ports
7.7.1.1 52
7.8.1.0 52
7.8.1.0 52
Stacking S-Series Switches | 1041